www.megger.comEVX10010Operation 4.1 Battery status and chargingNOTE : The EVX must be fully charged before use.If the EVX100 is fully charged the LED will flash Green, Yellow or Red every 10 seconds indicating battery status, as below:Green:100% to 50% charge remainingYellow:50% to 20% charge remainingRed:<20% charge remainingHolding down the button on the top of the EVX100 will also show battery status.4.2 Charging the EVX100NOTE : The EVX100 will only charge over an ambient temperature range of 0 ºC to 45 ºC.Charging the EVX100 battery status is performed using a type C USB cable.1. Disconnect the EVX100 from the EV charger.2. With the EVX100 removed from the MFT-X1 the USB-C charging port is exposed. To charge the EVX100 connect the adaptor to a suitable USB-C source.The Charge status is indicated by the top LED. Solid GREENEVX100 is chargedFlashing GREENEVX100 is chargingRed:A charging error has occurred – contact Megger technical support4.3 Hot keys:Hot key functionality is a subset of those offered on the MFT-X1 under normal operating conditions, i.e. non-EVX mode. Hot key functionality varies with the individual test modes selected. Refer to the individual test mode below for details of hot key functions.Hot key options can also be selected using the right rotary knob. Pre-test inspection and verification requirements.WARNING : The EVX100 performs live testing of the EV charger. Consequently, before the EVX100 is connected to the EV Charger all the standard tests that would be carried out on any newly installed circuit should be complete before the equipment is made live.4.4 Updating the MFT-X1 firmwareThe MFT-X1 must be upgraded to the latest version of firmware to ensure the EVX100 will operate. For full details of updating the MFT-X1 firmware visit www.megger.com/mft-x1. On the MFT-X1 product page select the Product Support tab, then select Software and Firmware updates from the right-hand options list. Follow the instructions to download the latest firmware update.NOTE : The Update process requires a micro-SD card to transfer the .BIN file to the MFT-X1.
Previous page: EVX100-adapter till laddningspunkter för elfordon ug [9 / 24]
Next page: EVX100-adapter till laddningspunkter för elfordon ug [11 / 24]
