10. PE Error - Earth Fault simulationWith the CP state set to either C or D (EV connected and ready to charge) and the PP state set to any setting except NC, by pressing the PE Error button, a disconnection of the PE conductor is simulated. The pending charging process should stop immediately and new charging processes are prevented.11. Phase indicatorsThere are three LED lamps (L1, L2 and L3), one for each phase. When the EVCA210 adaptor is connected to the charging point, the LED indicators will illuminate when phase voltages are detected with respect to neutral.Notes:In the case of no neutral (N) conductor the LED indicators will not indicate voltage on the L1, L2 or L3 conductors.LED indicators cannot be used for phase sequence testing or indication.If the charging point has a single-phase output, only one LED (L1) will illuminate.12. Plug socketThe mains plug socket on the EVCA210 is intended for measuring purposes only. It is connected to the L1, N and PE terminals of the charge point, so appropriate test instruments may be connected to the mains plug socket for testing. In addition, this socket gives the ability to check any electric power meter monitoring the charge point is working and/or counting correctly (load test). Therefore, an external load may be connected, but for measuring purposes only. The maximum current is limited to 10 A. The EVCA210 is protected against overload with a 10 A fuse. With the EVCA connected to the charging point:Line – Provides connection to L1 phase of charging point output plug/socket onlyNeutral – Provides connection to Neutral pin charging point output plug/socket Earth – Provides connection to Earth pin of charging point output plug/socketThe type of mains socket depends on the version of the EVCA210 Adaptor purchased:EVCA210-UK Front mains socket = UK 13A socket EVCA210 Front mains socket = Schuko socket (CEE 7/3) EVCA210-CH Front mains socket = Type J (SEV 1011) EVCA210-AU Front mains socket = Type I (AS 3112)13. 4 mm Measuring Terminals L1, L2, L3, N and PEThese are directly connected to the L1, L2, L3, N and PE conductors of the tested charging point via the connection cable. These ports are to be used ONLY for measuring purposes using an appropriate test instrument. No load should be connected across any of the terminals. With the EVCA connected to the charging point using one of the two available charging plugs:L1 – Provides connection to L1 phase of the charging point output plug/socket L2 – Provides connection to L2 phase of the charging point output plug/socket L3 – Provides connection to L3 phase of the charging point output plug/socket N – Provides connection to Neutral of the charging point output plug/socket E – Provides connection to Protective Earth of the charging point output plug/socketwww.megger.comEVCA210 12PE Error - Earth Fault simulation
Previous page: EVCA210 laddpunktsadapter för elfordon [11 / 16]
