WWW.MEGGER.COM 5every time a test trips a protective device such as an RCD or RDC. As protective devices are often located a considerable distance from the charge point, this feature can save a lot of time and walking.As an alternative to the EVX100, Megger offers the EVCA210 charge point adaptor, which is compatible not only with the MFT-X1, but also with other modern installation testers. The EVCA210 uses a cable to connect to the installation tester and has its own controls. It provides facilities similar to the EVX100 adaptor, except that automated testing is not supported.To help users work safely, the EVX100 and EVCA210 incorporate a range of safety functions. These include a PE pre-test feature that warns users of the presence of potentially dangerous voltages before they proceed with testing.The EVX100 and EVCA210 adaptors make provision for safe, easy connection to the charge point. They are supplied with Type 2 connectors as standard and Type 1 connectors are available as an option, making it possible to test the vast majority of Mode 2 and Mode 3 charge points currently in use.5MFT-X1 Multifunction Tester ► True Loop™ test with patented Confi dence Meter™ ► CertSuite™ compatible Bluetooth® result transfer ►User upgradeable operating system ►High resolution 0.001Ω loop test ►Automatic volt-drop measurement ►Stabilised insulation test voltage ►Confi gurable RCD and EV auto-sequence tests ►Fast switch rechargeable plug-in battery pack ►Full colour TFT bonded display ►Re-designed lead set and carry case solution ►IP54 operational housing ► Next generation 2-wire and 3-wire non-trip loop testingEVCA210 Electric vehicle charge-point adaptor ►Comply with Low Voltage Directive LVD 2014/35 ►Push button for PE Error (Earth Fault) simulation ►Rotary switch providing PP State simulation ►Rotary Switch providing CP State simulation ► Type 1 to Type 2 Adaptor available (Supplied as standard with the EVCA210-UK) ►Push button for CP Error “E” simulation ►Push Button for PE Pre-Test ►CAT II 300V RatingEVX100 Electric vehicle charge-point adaptor ►Test and certify single- and three-phase Mode 3 charge points up to 22 kW ►Fully integrated solution with no trailing interconnection cables ►Intuitive user interface using the MFT-X1 ►Automatic confi rmation of correct mode selection ►Automated testing – no manual cycle ►High capacity internal battery with USB-C charging port ►Type 2 charger connector supplied as standard, Type 1 available as an option ►Instant production of reports and certifi cates with CertSuite Installation
Previous page: Meggers lösningar för elfordonstestning [4 / 8]
