www.megger.comEVX1006Safety Warnings and Standards2. Safety Warnings and StandardsThese safety warnings must be read and understood before the instrument is used. Retain for future reference.EVSE: Electric Vehicle Supply (Charging) Equipment2.1 Warnings, Cautions and NotesThis user guide follows the internationally recognised definition. These instructions must be adhered to at all times.DescriptionWARNING : Indicates a potentially dangerous situation which, if ignored, could lead to death, serious injury or health problems. CAUTION : Indicates a situation which could lead to damage of the equipment or environmentNOTE : Indicates important instructions to be followed to perform the relevant process safely and efficiently.2.2 Safety warnings The equipment must be used only by suitably trained and competent persons. National Health and Safety Legislation requires users of this equipment or their employer to carry out valid risk assessment of all work so as to identify potential sources of danger and to mitigate risk. If this equipment is modified or used in a manner other than specified by the manufacturer, the protection provided by the equipment may be impaired. This equipment is not intrinsically safe and must not be used in hazardous atmospheres. This equipment is for indoor and outdoor use up to 2000 m altitude. It must not be used in wet conditions or outside the specified temperature range. If the equipment gets wet, disconnect and do not use. Clean equipment with a dry, clean cloth. Inspect the equipment for damage before each use. The equipment must not be used if any part of it is damaged. Voltage measurements must not be relied on, and independent means used to verify whether circuits are energised. If no voltage is measured, this may be because an EVX’s internal fuse has blown. Do not use the EVX if the MFT fails to detect it. Continuity of protective conductors and earthed equipotential bonding of new or modified installations must be verified before powering up the EVSE to be tested. Plug in the EVX to the MFT before connecting to the EVSE to be tested. Similarly, disconnect from the EVSE before unplugging the EVX and MFT. Do not connect USB cable when EVX is connected to EVSE. Use only Megger approved adapters with this product.
Previous page: EVX100-adapter till laddningspunkter för elfordon ug [5 / 24]
Next page: EVX100-adapter till laddningspunkter för elfordon ug [7 / 24]
